Categories

Categories

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
Slot Car Corner Canada

Categories

Categories

Tinned Steel Braid (magnetic)

$420.00 $395.00
(You save $25.00)

Tinned Steel Braid (magnetic)

$420.00 $395.00
(You save $25.00)
SKU:
MBRD
Current Stock:
Out of stock

Out of Stock

Share

Product Description

Magnetic Tinned Steel Track Braid (1/4" Wide x 500 Ft. Roll)

We offer high-quality, 1/4" wide tinned steel braid (magnetic) just like the braid used by many commercial and club raceways.  This braid provides excellent electrical connectivity with very high "ampacity" (safe current carrying capacity) without the drawbacks of copper tape (e.g. limited ampacity, breakage, lifting, electrical connectivity issues).  The 1/4" track braid we offer is also compatible with several other track building components we offers such as router bits, 2-sided tape and braid rollers.  Unlike the flimsy metal spools some of our competitors use, our braid is spooled on high-quality, heavy duty plastic spools.  These spools provide much better protection for the braid during shipment.

 

 

Note #1:

Most rolls of braid are one continuous length (piece) of braid; however, it is possible to have rolls with 2 pieces.  Therefore, when installing braid, please note the following:

  • If you plan to install the braid directly from the spool, you may reach the end of a length of braid before reaching the end of the current section of track you are braiding.  Should this happen, simply drill a 1/4" hole in the gain so there will still be at least 10-12" of the current piece of braid to "drop" through the hole.  Insert the first 10-12" of braid from the next piece of braid into the hole and continue braiding.  The ends of the two pieces of braid that were "dropped" under the table can be connected using an electrical wire nut.
  • If you want to ensure you have enough braid for the next section of track you will be braiding, you will need to measure how much braid is required (don't forget to leave 10-12" on both ends for your "drops").  Once you have determined the length of braid required, measure and cut a piece of braid from the spool.
  • In general, if you are braiding long segments of track (30+'), the first method described above (working directly from the spool) is easier to use.  If you are planning to braid shorter lengths of track (or the track is broken up into individual sections which will be braided individually), either method can be used.  If you don't want additional "drops" within a given segment, use the second method.

 

  • Tip - All braid has a fine residue from the manufacturing process.  For best adhesion, wipe the braid lightly with a lint-free rag soaked in laquer thinner prior to installation.  Let the laquer thinner evaporate prior to installation.  Use rubber gloves and follow all applicable safety precautions.
     

FAQ

  1. How thick is this braid?  Answer: The manufacturer's specification data for this braid indicates the thickness is .030"; however, actual thickness is typically about .026".

Find Similar Products by Category